Rejected takeoff

(Redirected from Aborted take-off)

In aviation, a rejected takeoff (RTO) or aborted takeoff is the situation in which the pilot decides to abort the takeoff of an airplane after initiating the takeoff roll but before the airplane leaves the ground.

Reasons to perform a rejected takeoff vary but are usually related to a suspected or actual problem with the aircraft, such as an engine failure; fire; incorrect configuration; aircraft control issue; unusually slow acceleration; automated warning signal(s) indicating a critical system failure; environmental conditions such as predictive windshear; or an instruction from air traffic control.

There are three phases of a takeoff. In the low-speed regime, usually below 80 kts or so, the takeoff will be rejected even for minor failures. In the high-speed regime, above usually 80 kts but below V1, minor problems are ignored, but the takeoff will still be rejected for serious problems, in particular for engine failures. The takeoff decision speed, known as V1, is calculated before each flight for larger multi-engine airplanes. Below the decision speed, the airplane should be able to stop safely before the end of the runway. Above the decision speed, the airplane may overshoot the runway if the takeoff is aborted, and, therefore, a rejected takeoff is normally not performed above this speed, unless there is reason to doubt the airplane's ability to fly. If a serious failure occurs or is suspected above V1, but the airplane's ability to fly is not in doubt, the takeoff is continued despite the (suspected) failure, and the airplane will attempt to land again as soon as possible. If the airplane's ability to fly is in doubt (for instance, in the event of a major flight-control failure which leaves the airplane unable to rotate for liftoff), the best option may well be to reject the takeoff even if after V1, accepting the likelihood of a runway overrun.

Single-engine aircraft will reject any takeoff after an engine failure, regardless of speed, as there is no power available to continue the takeoff. Even if the airplane is already airborne, if sufficient runway remains, an attempt to land straight ahead on the runway may be made. This may also apply to some light twin-engine airplanes.

Before the takeoff roll is started, the autobrake system of the aircraft, if available, is armed. The autobrake system will automatically apply maximum brakes if throttle is reduced to idle or reverse thrust during the takeoff roll once a preset speed has been reached.

Testing

edit

An RTO is usually seen as one of the most challenging tests an airplane has to undergo for its certification trials. The RTO test is performed under the worst possible conditions; i.e. with fully worn out brakes, the plane loaded to maximum takeoff weight and no use of thrust reversers. During an RTO test most of the kinetic energy of the airplane is converted to heat by the brakes, which may cause the fusible plugs of the tires to melt, causing them to deflate. Small brake fires are acceptable, providing that in the first five minutes, they do not prejudice the safe and complete evacuation of the aircraft.[1]

edit

See also

edit

References

edit
edit
  • Airliners.net – Photos detailing a RTO performed by a Lockheed Tristar at Amsterdam Schiphol Airport Archived 2012-03-09 at the Wayback Machine
  • History of RTO Operations at Evergreen with good explanatory notes
  • Fred George (Jul 21, 2017). "The Go/No-Go Decision: High-Speed RTOs Are Fraught With Risk". Aviation Week Network.
  • Boeing 747-8 rejected take-off test, 2011
  NODES
HOME 1
languages 1
mac 1
Note 2
os 6